Probleme mit OpenATV 6.3

<6>[ 106.082000] usb 1-1: new high-speed USB device number 2 using ehci-brcm
<6>[ 106.223000] scsi2 : usb-storage 1-1:1.0
<5>[ 107.233000] scsi 2:0:0:0: Direct-Access SanDisk Ultra Fit 1.00 PQ: 0 ANSI: 6
<5>[ 107.260000] sd 2:0:0:0: [sdb] 31266816 512-byte logical blocks: (16.0 GB/14.9 GiB)
<5>[ 107.263000] sd 2:0:0:0: [sdb] Write Protect is off
<7>[ 107.264000] sd 2:0:0:0: [sdb] Mode Sense: 43 00 00 00
<5>[ 107.265000] sd 2:0:0:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
<6>[ 107.310000] sdb: sdb1
<5>[ 107.330000] sd 2:0:0:0: [sdb] Attached SCSI removable disk
<3>[ 169.035000] EXT4-fs (sdb1): couldn't mount RDWR because of unsupported optional features (400)
<3>[ 169.139000] EXT4-fs (sdb1): couldn't mount RDWR because of unsupported optional features (400)
<3>[ 187.861000] EXT4-fs (sdb1): couldn't mount RDWR because of unsupported optional features (400)
<3>[ 187.963000] EXT4-fs (sdb1): couldn't mount RDWR because of unsupported optional features (400)

root@dm800se:~/logs#

Zum Vergrößern anklicken....

1. install brew, visit
   Sie müssen registriert sein, um Links zu sehen.
2. install e2fsprogs using brew install e2fsprogs
3. figure out the name of your partition or drive using diskutil list -- in my case, my partition had was on disk2 and had the identifier of disk2s1
4. sudo $(brew --prefix e2fsprogs)/sbin/mkfs.ext3 /dev/disk2s1 but you may need to change the drive from disk2s1 to the partition or drive that you want to format. This command will ask you to verify the name of the partition, just to be sure